[. . . ] : +49 7195 14-0 Fax: +49 7195 14-2212 Winnenden, 2013/02/01 12 CEO Head of Approbation DE – 10 Please read and comply with these original instructions prior to the initial operation of your appliance and store them for later use or subsequent owners. € Before first start-up it is definitely necessary to read the safety indications Nr. € The non-compliance of the operating and safety instructions may lead to damages of the appliance and to dangers for the operator and other persons. – In case of transport damage inform vendor immediately Environmental protection The packaging material can be recycled. [. . . ] σ While vacuuming the appliance, use at least one vacuum cleaner of the same or higher classification. Safety filter bag You must insert a safety filter bag into the vacuuming material container to empty the appliance without causing dust:  Insert the safety filter bag into the container and attach it carefully to the container wall. σ Put over the edge of the bag over the rim of the vacuuming material container. σ Insert the vacuuming material container back into the appliance. σ After use, close the safety filter bag and remove it from the vacuuming material container. σ Dispose of the safety filter bag with its contents according to the applicable regulations. Emptying the vacuuming material container To avoid too much filling of the vacuuming material container, you need to check it regularly depending on the type and volume of the sucked in material. σ Switch off the appliance and secure it using the parking brakes at the guide rollers. Monitoring the suction performance The machine is equipped with a suction power monitor. If the air speed in the suction hose falls below 20 m/s, the manometer will display 19. 5 kPa: Perform the following activities to regain the prescribed air speed of more than 20 m/s:  Switch off the appliance using the On/ Off switch. σ Clean the filter (see chapter "Cleaning the filter"). If these measures do not lead to the desired reduction in pressure display:  Switch off the machine and replace the filter (see chapter "Replacing filter"). σ Open the vacuuming material container upward at the lock (see figure). EN – 5 17  Pull out the vacuuming material container from the appliance using the handle that has been provided for the purpose. Note The vacuuming material container needs to be emptied if it is full until about 3 cm below the upper rim. σ After use, close the safety filter bag with a cable tie and remove it from the vacuuming material container. σ Dispose of the safety filter bag according to the local provisions. σ Clean the container from the insides before inserting a new safety filter sack. σ Insert a new safety filter bag into the vacuuming material container and insert it back into the appliance using the reverse sequence. Maintenance and care ṇ Warning First remove the mains plug before doing any job on the vacuum cleaner. Dust extracting machines are safeguards for the prevention or elimination of hazards defined in the regulations of BGV A1. [. . . ] We will repair potential failures of your appliance within the warranty period free of charge, provided that such failure is caused by faulty material or defects in manufacturing. In the event of a warranty claim please contact your dealer or the nearest authorized Customer Service centre. EN – 8 Accessories and Spare Parts – EC Declaration of Conformity We hereby declare that the machine described below complies with the relevant basic safety and health requirements of the EU Directives, both in its basic design and construction as well as in the version put into circulation by us. This declaration shall cease to be valid if the machine is modified without our prior approval. [. . . ]